10. CRANKCASE/CRANKSHAFT/KICK STARTER/TRANSMISSION K-PIPE 125 Right Left Inspect the transmission drum for scratches or poor lubrication. Check the transmission drum grooves for damage. Check the bearing for excessive free play. Measure the transmission drum O.D. Service Limits: Left : 13.05mm replace if below Right : 16.10mm replace if below Check the transmission drum and transmission fork shaft holes in the left and right crankcase halves for wear or damage. TRANSMISSION BEARING INSPECTION Turn the inner races of the bearings with your finger. The bearings should turn smoothly and quietly. Also check that the outer races of the bearings fit tightly in the crankcase. Replace the bearings if they are abnormal (page 10-10) ASSEMBLY Apply clean engine oil to the sliding and rotating surfaces of the gears, bushings and shafts. Assemble the main shaft and countershaft, Install the snap rings aligning their end gaps between the shaft teeth as shown. Make sure the snap rings are seated securely in the grooves of the shafts. Main Shaft M4 (24T) M3 (21T) M2 (17T) M1 (12T) C4 (23T) C3 (26T) C2 (30T) Countershaft C1 (34T) 10-9