18.LIGHTS/INSTRUMENTS/SWITCHES/HORN/ FUEL UNIT K-PIPE 125 SERVICE INFORMATION GENERAL INSTRUCTIONS · All plastic plugs have locking tabs that must be released before disconnecting. · An electric tester must be used for checking the continuity between two points. The electric tester also contains a voltmeter which can be used to measure voltage. · Different bulbs have different specifications. When replacing, use a new bulb of the same specifications to avoid damage of the electrical equipment. · The continuity check of switches can be made without removing the switches from the motorcycle. SPECIFICATIONS Headlight 12V 35/35W Stoplight/Taillight 12V 21/5W Turn signal light 12V 10Wx4 Turn signal indicator light 12V 3.4W x2 Instrument light 12V 1.7Wx2 High beam indicator light 12V 1.7W Fuse 10A TROUBLESHOOTING Light does not come on when ignition Headlight beam does not change when switch is "ON" dimmer switch is operated · Burned bulb · Faulty or burned bulb · Faulty ignition or light switch · Faulty dimmer switch · Fuse burned out · Loose wire connection · Dead battery or loose battery wire Light comes on but dims · Weak battery · Wire or switch resistance too high · Aged bulb or faulty lighting circuit 18-1