kpw 125 Manuale-dofficina : Pagina 149

          13. HYDRAULIC BRAKE                                                 K-PIPE 125


 ASSEMBLY
 Before assembly, apply brake fluid to all
 removed parts.
 Install the spring together with the 1st rubber
 cup.
 · During assembly, the master cylinder,
     main piston and spring must be
     installed as a unit without exchange.
   · When assembling the piston, soak the
     cups in brake fluid for a while.

                                                                     Fluid Tube Bolt
 Install the main piston and snap ring.
 Install the rubber cover.
 Install the brake lever.




 Place the brake master cylinder on the
 handlebar and install the master cylinder
 holder with the "UP" mark facing up,
 aligning the tab on the holder with the hole
 in the handlebar.
 First tighten the upper bolt and then tighten
 the lower bolt.
 Torque: 1.01.4kg-m


                                                   "UP" Mark
                                                            Sealing Washer        Bolt
 Install the brake fluid tube with the bolt and
 two sealing washers. Then, install the
 rearview mirror.
 Fill the brake reservoir with recommended
 brake fluid to the upper level.
 Bleed air from the hydraulic brake system.
 (Refer to 13-4.)




                                                                              13-8