15. REAR WHEEL/AXLE/SHOCK ABSORBER/SWING ARM MXU 500 IRS REAR WHEEL REMOVAL/INSPECTION/ INSTALLATION REMOVAL Place the machine on a level place. Remove four nuts from rear wheel. Elevate the rear wheels by placing a suitable stand under the frame. Support the machine securely so there is no danger of it falling over. Remove the rear wheel and wheel hub nut cap together. INSPECTION Measure the wheel run out. Replace wheel or check bearing play if out of specification Rim run out limits: Vertical: 2 mm (0.08 in) Lateral: 2 mm (0.08 in) INSTALLATION When reinstalling a wheel, tighten the wheel nuts in a crisscross (rather than a circular) pattern. Torque: 5.5 kgf-m (55 N-m, 40 lbf-ft) Be sure the tapered side of the wheel nuts face the wheel rim. 15-3