like 50 2T 1 Manuale-dofficina : Pagina 177

          16. INSTRUMENT/SWITCHES/LIGHTS                                                       LIKE 50 2T
                                                                  Fuel Unit
    INSTALLATION
    The installation sequence is the reverse of
    removal.
 · Install the fuel unit at the connect
       position.
    OIL METER
    INSPECTION
    Remove the met-in box. ( 12-4)
    Remove the frame body cover. ( 12-4)
    Disconnect the oil meter wire connectors
    and remove the oil meter. Keep the oil
                                                                  Wire Connector
    meter float at the lower position.
    Measure the resistances between the wire
    terminals as and shown in the left                Oil Meter                                B
                                                                         G/R               G
    figure.                                                                    B

         Wire Terminals            Resistance
     Green/Red(+)Black(-)              46
       Green(-)Black(+)                 

 Before removing the oil meter, be sure
      to drain the motor oil and do not allow
      sparks or flames near the working area.             Float

    Oil Meter Operation Inspection
    Connect the oil meter wire connectors and
    turn the ignition switch ON.
    Measure the resistance between the wire
    terminals with the float at upper position.

    Green/Red(+)Black(-)          About 300
                                                                         Light OFF
 Before performing the following test,                                         Light OFF
      operate the turn signals to determine
      that the battery circuit is normal.                               Light ON      4.51.0mm




    Move the oil meter float up and down to see                                                    Oil Indicator
                                                                                                       Light
    if the oil indicator light will go out and come
    on.
 If the oil indicator light does not light,
      check for burned bulb, loose wire or
      connector. After correction, check again
      according to the method mentioned
      above.

3