3. INSPECTION/ADJUSTMENT MXU 550EXi/MXU500i Wrench Thickness Gauge Valve Adjusting Adjust by loosening the valve adjusting screw lock-nut and turning the adjusting screw until there is a slight drag on the thickness gauge. Valve clearance (when cold): IN.: 0.1 mm EX.: 0.1 mm Apply oil to the valve adjusting screw lock- nut threads and seating surface. Hold the adjusting screw and tighten the Lock Nut lock nut. Special tool: Valve adjusting wrench A120E00080 Torque: 0.9 kgf-m (9 N-m) After tightening the lock nut, recheck the valve clearance. Install the removed parts in the reverse order of removal. IDLE SPEED INSPECTION The engine must be warm(80°C over) for accurate idle speed inspection Warm up the engine before this operation. Start the engine and connect a tachometer or kymco diagnostic tool. attached the specified idle speed. Idle Speed: 1400100 rpm Idle Speed 3-11