18. LIGHTS / SWITCHES MXU 500EXi/MXU500i IGNITION SWITCH INSPECTION Disconnect the ignition switch connectors. (Refer to the "FRAME COVER" section in the chapter 2.) Check for continuity between the switch side connector terminals in each switch position. Continuity should exist between the color coded wires as right: REPLACEMENT Release the switch wire from the wire clips on the steering shaft holder frame pipe. Remove the meter cover (refer to the "FRAME COVER" section in the chapter 2). Remove the ignition switch from the cover while pushing in the two stoppers. Install a new ignition switch by aligning the locating tab with the groove in the cover. Install the removed parts in the reverse order of removal. HANDLEBAR SWITCH INSPECTION Remove front center cover (refer to the "FRAME COVER" section in the chapter 2). Disconnect the connectors. Check for continuity between the switch side connector terminals in each switch position. Continuity should exist between the color coded wires as next page: 18-5