17. BATTERY/CHARGING SYSTEM MXU 550EXI/MXU500I INSTALLATION Install the stator and tighten the stator mount bolts to the specified torque. Torque: 1.2 kgf-m (12 N-m) Apply sealant to the grommet seating surface and install it to the cover groove properly. Install the pulse coil and tighten mount bolts to the specified torque. Torque: 1.2 kgf-m (12 N-m) Stator Grommet Pulse Coil Clean the mating surfaces of the right Dowel Pins crankcase and cover. Install the dowel pins and gasket. Gasket Install the right crankcase cover and tighten the bolts in a crisscross pattern in 2 or 3 steps. FLYWHEEL: Refer to the "STARTER CLUTCH REMOVAL/INSPECTION/INSTALL ATION" section in the chapter 19 Right Crankcase Cover 17-12