16. BRAKE SYSTEM MXU 550EXi/MXU 500i FRONT BRAKE CALIPERS REMOVAL/INSTALLATION REMOVAL Drain the brake fluid from the hydraulic brake system (refer to the "FRONT BRAKE FLUID CHANGE/AIR BLEED (OFF ROAD)" section or "COMBINATION BRAKE FLUID CHANGE/AIR BLEED (ON ROAD)" section in this chapter). Remove the brake fluid hose bolt and two washers from the caliper. Remove the brake pads (refer to the "BRAKE PADS REPLACEMENT" Fluid Hose Bolt/Washers section in this chapter). Remove the brake caliper. INSTALLATION Install the brake fluid hose with the attaching bolt and two new sealing washers, then tighten the bolt to the specified torque. Torque: 3.5 kgf-m (35 Nm, 25 lbf-ft) Fill the specified brake fluid and bleed air from the brake system (refer to the "FRONT BRAKE FLUID CHANGE/AIR BLEED " section or "COMBINATION BRAKE FLUID CHANGE/AIR BLEED " section in this chapter). 16-34