16. BATTERY/CHARGING SYSTEM/
A.C. GENERATOR MXU 250R/300R
VOLTAGE REGULATION TEST
Connect a voltmeter across the battery Black
terminals.
Start the engine and gradually increase the
engine speed.
The battery terminal voltage should be
within 1415 V.
A.C. GENERATOR INSPECTION
This test can be made without removing
the stator from the engine.
Disconnect the A.C. generator connector.
Check the continuity between the yellow
wires and ground.
There should be continuity between the
yellow wires and no continuity between
each yellow wire and ground.
Resistance (at 20°C):
YellowYellow 1.62.5 A.C. Generator Bolts Set Plate
A.C. GENERATOR/FLYWHEEL
REMOVAL
Remove the right crankcase cover. (Refer to
the "WATER PUMP SHAFT REMOVAL"
section in the chapter 12)
Remove the pulser coil screws and then
remove the A.C. generator wire set plate. Pulser Coil Screws
Remove the A.C. generator bolts and then
remove A.C. generator and pulser coil from
right crankcase cover.
When removing the pulser coil and
stator, be careful not to damage them to
avoid shorted or broken wire.
Remove the oil through guide and spring.
Oil Through Guide Spring
16-7
Veloci e precisi, prezzi nella media. 
4.7 / 5