3. INSPECTION/ADJUSTMENT LIKE 200i ELECTRICAL EQUIPMENT IGNITION APPARATUS Gap, Wear and 0.6-0.7mm Spark Plug Fouling Deposits Remove the frame center cover. Remove the spark plug cap and spark plug. Check the spark plug for wear, fouling and carbon deposits. Remove the fouling and carbon deposits Washer Damage with a spark plug cleaner or wire brush. Cracks Specified Spark Plug Cracks NGK SF10JA CR7HSA Spark Plug Gap: 0.60.7mm Fan Ignition Apparatus The CDI ignition timing is not adjust- able. If the timing is incorrect, check the CDI unit, ignition coil and A.C. generator and replace any faulty parts. Remove the right side rail. ( 12-4) Remove the A.C. generator fan cover. ( 7-3) Remove the three bolts attaching the fan cover and then remove the fan cover. Warm up the engine and check the ignition timing with a timing light. Index Mark When the engine is running at the specified rpm, the ignition timing is correct if the "F" mark on the flywheel aligns with the index mark on the crankcase within 1.5°. Ignition Timing: 13.5°1°BTDC/2000rpm F Mark 7