15. REAR BRAKE/REAR FORK/REAR WHEEL/REAR SHOCK ABSORBER GRAND DINK 250 Fluid Tube Bolt REAR BRAKE REAR BRAKE CALIPER REMOVAL First remove the exhaust muffler. ( 2-6) Remove the rear brake fluid tube bolt and disconnect the brake fluid tube. Remove the two bolts attaching the rear brake caliper. Remove the rear brake caliper. When removing the brake fluid tube, use shop towels to cover plastic parts and Brake Caliper Bolts coated surfaces to avoid damage. Brake Disk INSPECTION Inspect the brake pads and brake disk. Visually check the brake pad thickness and it should not exceed the wear indicator mark. Measure the brake disk thickness. Service Limit: 3.0mm replace if below Brake Pads DISASSEMBLY Disassemble the rear brake caliper. ( 14-11) Inspect and assemble the rear brake caliper . ( 14-12) Note: The rear brake caliper and front brake caliper have the same specification. Wear Indicator Mark Remove the two brake pads dowel pins and three bolts from the brake caliper. Remove the brake pads. Dowel Pin Bolts 15-3