14.STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK ABSORBER/FRONT FORK GRAND DINK 250 Brake Master Cylinders STEERING HANDLEBAR REMOVAL Remove the handlebar front and rear covers. ( 2-6) Remove the front and rear brake master cylinder attaching bolts. Remove the front upper cover. ( 2-5) Remove the front lower cover. ( 2-5) Remove the floor board. ( 2-4) Remove the leg shield. ( 2-5) Bolts Throttle Grip Remove the four screws attaching the right and left handlebar switches. Disconnect the throttle cable from the throttle grip and remove the throttle grip from the handlebar. Screws Throttle Cable Remove the handlebar lock nut and take out the bolt. Remove the handlebar. Lock Nut Bolt INSTALLATION Install the handlebar onto the steering stem and install the handlebar collar, lock nut and bolt. Tighten the bolt to the specified torque. Torque: 39.249N-m Collar 14-4