13. FUEL SYSTEM/CARBURETOR/ FUEL PUMP/ FUEL TANK GRAND DINK 250 Fuel Pump Outlet Tube Inlet Tube FUEL PUMP INSTALLATION Install the fuel pump and secure it with the two bolts. Connect the fuel pump inlet, outlet and vacuum tubes. Install the seat, met-in box and frame center cover. Vacuum Tube Fuel Strainer Fuel Pump Outlet Tube Measure the fuel pump output. Start the engine and disconnect the fuel outlet tube and place a clean container under the tube to check the fuel output. Output: 40cc/1700rpm/10 seconds . Container Fuel Unit Fuel Vapor Tube FUEL TANK REMOVAL Remove the floor board. ( 2-4) Remove the leg shield . ( 2-5) Disconnect the fuel unit wire connector. Remove the fuel tube between the fuel tank and the fuel filler. Disconnect the fuel vapor tube. Remove the fuel tank. The installation sequence is the reverse of removal. Fuel Strainer Tube to Fuel Filler 13-20