16. STARTING SYSTEM AGILITY CITY 125 Lock Nut Remove the starter clutch lock nut. Special Flywheel Holder Note that the lock nut is left threaded. Remove the starter clutch. Remove the starter idle gear and shaft. Flywheel Holder INSPECTION Inspect the operation of the starter drive gear when it is assembled on the clutch. The starter drive gear should turn clockwise freely and should not turn counterclockwise. STARTER CLUTCH DISASSEMBLY Inspect the starter drive gear for wear or damage and replace if necessary. Measure the starter drive gear I.D. Service Limit: 32.06mm replace if over Inspect the needle bearing for wear or damage and replace if necessary. Starter Drive Gear Needle Bearing Clutch Body CLUTCH BODY DISASSEMBLY Remove the rollers, plungers and springs from the clutch body. Inspect the clutch body for wear or damage and replace if necessary. Inspect each roller and plunger for wear or damage and check for weak spring. Replace if necessary. Spring Roller 16-6