16. INSTRUMENT/SWITCHES/LIGHTS AGILITY CITY 50 2T Fuel Unit INSTALLATION The installation sequence is the reverse of removal. · Install the fuel unit at the connect position. OIL METER INSPECTION Remove the met-in box. ( 12-4) Remove the frame body cover. ( 12-4) Wire Connector Disconnect the oil meter wire connectors and remove the oil meter. Keep the oil meter float at the lower position. Oil Meter B Measure the resistances between the wire G/R G terminals as and shown in the left B figure. Wire Terminals Resistance Green/Red(+)Black(-) 46 Green(-)Black(+) Before removing the oil meter, be sure to drain the motor oil and do not allow Float sparks or flames near the working area. Oil Meter Operation Inspection Connect the oil meter wire connectors and turn the ignition switch ON. Measure the resistance between the wire terminals with the float at upper position. Green/Red(+)Black(-) About 300 Light OFF 4.51.0mm Light OFF Before performing the following test, Light ON operate the turn signals to determine that the battery circuit is normal. Move the oil meter float up and down to see Oil Indicator Light if the oil indicator light will go out and come on. If the oil indicator light does not light, check for burned bulb, loose wire or connector. After correction, check again according to the method mentioned above. 16-3